Save on your
energy bill
with gridsoap®
the very first biodegradable
heat pump cleaner.
Over time, your heat pump becomes clogged.
Cleaning it with GridSoap® ensures a free
airflow between the fins, providing lower
energy consumption and improved performance
- Lower energy consumption
- Better performance
- Clean in less than 10 minutes
Increased yield
Energy absorption is optimised by free airflow between the fins when cleaned with GridSoap®. This results in lower energy consumption and better performance
Less icing
As GridSoap® provides a free flow of air, the balance in the system will not be disturbed, leading to a reduced risk of ice formation
Convenient & fast
GridSoap® is ready to use immediately and comes with a hand-held sprayer that allows you to adjust the dosage to the soiling of the evaporator or condenser of the heat pump or air conditioner. One cleaning takes barely 10 minutes.
No damage
A pressure washer pushes the fins flat, and both a hoover and an air compressor are not powerful enough to remove dirt between the fins. GridSoap® cleans between the fins and even the drainage area for condensation water.
Protection of fins
A protective coating by GridSoap® ensures that future dirt is less likely to adhere and makes the fins more resistant to corrosion.
Biologically degradable
Moreover, GridSoap® is biodegradable and therefore not harmful to plants around the heat pump site.
- Hover over me and see what I can do in just 10 minutes!
Save on your
energy bill
with gridsoap®
the very first biodegradable
heat pump cleaner.
Lower energy consumption of heat pump
not harmful to plants
biodegradable
clean in less than
10 minutes
Lower energy consumption of heat pump
not harmful to plants
clean in less than
10 minutes
biodegradable
Frequently Asked Questions
No, GridSoap® is formulated so that it is biodegradable and the planting around it is not at any chemical risk.
Yes, because the heat pump will again have free airflow through the fins, the heat pump will absorb more energy than with a fouled evaporator or condenser. This ensures an optimal balance between energy recovered and energy expended (COP).
Depending on contamination, we recommend annual maintenance with GridSoap® to ensure free airflow between the fins.
Yes, just spray GridSoap® on the fins, let it soak for 10 minutes and then rinse off with a garden hose.
The only supplies are GridSoap® and a garden hose.
You can decide how much you want to use, but we recommend using the amount mentioned. For an appliance smaller than 15 kW, you will need about 0.5 litres, and for an appliance larger than 15 kW and smaller than 30 kW, you will need about 1.0 litres.
Yes, there are clear instructions on the label, along with helpful images.
View our distributors